madbeanpedals::forum

General => Open Discussion => Topic started by: Gledison on February 19, 2014, 04:14:54 PM

Title: Sunking, etching .pdf file
Post by: Gledison on February 19, 2014, 04:14:54 PM
Hello Etchers,
I was printing the Sunking project and i noticed that the etching layout is somehow displayed a little bit on the bottom half.
I tried to repair it but im afraid of screwing up more..
anyone has etched this board? any lost version somewhere?
thanks in advance
Title: Re: Sunking, etching .pdf file
Post by: selfdestroyer on February 19, 2014, 04:54:38 PM
The PDF in the "Discontinued Projects" thread sees to be fine.
http://www.madbeanpedals.com/projects/Sunking/docs/Sunking_ver.3.pdf (http://www.madbeanpedals.com/projects/Sunking/docs/Sunking_ver.3.pdf)

Is that what you need?

Cody
Title: Re: Sunking, etching .pdf file
Post by: Gledison on February 19, 2014, 09:12:57 PM

Quote from: selfdestroyer on February 19, 2014, 04:54:38 PM
The PDF in the "Discontinued Projects" thread sees to be fine.
http://www.madbeanpedals.com/projects/Sunking/docs/Sunking_ver.3.pdf (http://www.madbeanpedals.com/projects/Sunking/docs/Sunking_ver.3.pdf)

Is that what you need?

Cody
Hey Cody,
I have exactly this version. The etch ready to print layout is a little shifted.
I could try to correct on the illustrator but wanted to check first if there is any other version...
Thanks