Hi All,
I'm getting some pretty serious popping in this feedback looper (diagram below). Does anyone have any ideas of how to mitigate it? Would a pull down resistor/circuit work? If so, what components, values, and placement do I need to install one properly.
Also, I'm curious if it would work to wire a Bacon Bits into this circuit. This is how I was thinking of doing it:
1) use a toggle 3PDT switch
2) wire the "input" of the Bacon Bits to the "input" of the feedback/loop circuit
3) wire the "output" of the Bacon Bits to the "send" of the feedback/loop circuit
Additionally, I have not wired the Bacon Bits into the feedback/loop circuit, yet. The popping is happening with the just the feedback/loop circuit.
Thanks for any help!