Quote from: andregarcia57 on August 12, 2014, 04:18:10 PM
anyone have a PCB that would Dynacomp and tube screamer on the same PCB?
thanks
I'll respond to this in this thread, though you've got the same question in two.
To the best of my knowledge, I haven't seen anyone on here put out a 2 in 1 compressor/TS on the same board. I could be wrong.
You're best bet would be to buy a board of each, and in that regard you have a lot of options.
On the Tubescreamer side
Madbean - Green Bean
Rullywowr - 8Oh8
JMK PCBS - Steaming Kettle (it's built as a hotter overdrive, but you could build it back to a stock 808)
Aion - Stratus
General Guitar Gadgets - Tubescreamer
TH Customs - Tube screamer mini (save you some space in a two in one)
Pedalparts.co.uk - Tubescreamer, little screamer, son of screamer
There's more that, but it's a good start
Compressor side
pickdropper - four knob comp, it's the Keeley circuit, which is based on the Ross circuit, which is marginally different than the Dyna circuit and can be built the same.
jmkpcbs - Engineers Thumb, a variant of the Dyna/Ross model with lower noise
General Guitar Gadgets - Dynacomp
Pedalparts.co.uk - Skwisher
Any combination of those two boards should fit into a 1590BB in a landscape layout without much problem.
You could also go the vero route as Jimilee suggested, but doing a two in one on vero is less fun than it sounds.