Hi all
fairly new here, but been lurking for a long while, so i decided to introduce myself with a build.
It's a DBD on Mark's layout, pretty straightforward, only put a 20k trim instead of 12k resistor in ICB feedback loop because my last build was slightly below unity when engaged.
Enclosure is my first try at etching, it's ok i guess, but a little shallow as you can see i sanded a bit of paint in a couple of places. I pretty much followed selfdestroyer's tutorial, it's great. And my LED hole was too big at the end, but i managed.
here are the pics, not great, i only have a camera on my phone
(http://i58.tinypic.com/2ymg9xt.jpg)
(http://i61.tinypic.com/24y5x6g.jpg)
Awesome! That looks so sweet.... If you saw my horribly mangled first enclosures you would feel even better about this awesome build
Sent from my iPad using Tapatalk
thanks :D
hehe, everybody has mangled enclosures in their stash :D
Great job on your build. Your etch came out great. Do I also spy a old 1590B enclosure with a sponge in it for your soldiering iron? If so, that's a great little hack right there.
Cody