Long overdue Feng Drive PIF build report. Bit of a story to this one,, the I'll try to keep it as brief as possible. First off, thanks to Grind Customs for the Feng Drive pcb. It will certainly be used and abused. The pcb is so small that it was just begging to be used as a 2 in1. It took me a while to decide what to put it with and honestly, this happened by chance.
Originally this was going to be a Fat Pants clone ( something I made from Brian's schematic, created my own layout. Great way to learn EAGLE) and a Karate Shop. I don't know what I did wrong but these two did not get along in the same enclosure, too much noise. Probably something I did wrong
Anyway, I didn't want the enclosure to go to waste and since the Feng Drive had 4 knobs like the Karate Shop, it was an easy swap.
This combination gives me a great variety of overdrive and boost sounds for leads. I couldn't be happier! The outside isn't impressive but for me it's about the sound.
For me looks quite good
Good job Matt. Rock and roll!!
The sound is what it's all about. Great work Matt.
Steve.