Text only | Text with Images

madbeanpedals::forum

General => Open Discussion => Topic started by: mrclean77 on February 02, 2016, 01:10:03 AM

Title: DPDT question
Post by: mrclean77 on February 02, 2016, 01:10:03 AM
Will this switch fit the Tusk daughter board and/or the Opto board from 1776???

http://www.bitcheslovemyswitches.com/#!/Low-Profile-DPDT-Footswitch-Latched-Solder-Lugs/p/51019434/category=5027572 (http://www.bitcheslovemyswitches.com/#!/Low-Profile-DPDT-Footswitch-Latched-Solder-Lugs/p/51019434/category=5027572)


Never messed w pcb pin/pcb mount DPDTs and can tell you the other BLMS ones don't fit...oopsy

I think i found the correct ones at Mouser for double the moolah

TIA
Title: Re: DPDT question
Post by: flanagan0718 on February 02, 2016, 06:24:20 AM
I'm not sure about the Tusk board but i know it doesn't fit in the 1776 board. It does however fit in the Lumen board from GCFX nicely tho!
Title: Re: DPDT question
Post by: mrclean77 on February 02, 2016, 10:26:21 AM
Thank you!
Title: Re: DPDT question
Post by: flanagan0718 on February 02, 2016, 02:09:04 PM
I do have a Tusk and those switches, I could check it when I get home today.
Text only | Text with Images