Hi All.
I've built up a Weener Wah II and it's DOA signal-wise. I checked it with my testing rig before boxing and it was passing the test signal, so I thought all was well. After boxing I'm getting test signal EVERYWHERE I touch the probe except at the output ... and there doesn't seem to be any wah effect added to the test signal.
So, for starters, a couple of questions:
- How far should I disassemble this beast in order to troubleshoot effectively? Do I need to remove all the offboard wiring options?
- Is there a way to check the wah inductor once installed on the board to see if it's passing signal correctly (i.e. to check that I used the right holes for that inductor)?
Any advice or direction would be appreciated.
Thanks, Bruce.
Check your off board wiring and make sure nothing is grounding out.
Sent from my iPhone using Tapatalk