Text only | Text with Images

madbeanpedals::forum

Projects => General Questions => Topic started by: Tuxedo3 on June 15, 2016, 03:12:10 AM

Title: How does my drill template look for a Slow Loris/Green Bean 2-in-1?
Post by: Tuxedo3 on June 15, 2016, 03:12:10 AM
Okay, so I used the PCB layers from the drill templates for each individual pedal and put them onto a sideways 1590BB (DC jack will be above the boards). Never built a 1590BB before, how does this look?
Title: Re: How does my drill template look for a Slow Loris/Green Bean 2-in-1?
Post by: selfdestroyer on June 15, 2016, 04:12:35 AM
I would actually move the DC jack up more. The clearance with the pots look like it will be close.

Everything else looks fine to me.

Cody
Title: Re: How does my drill template look for a Slow Loris/Green Bean 2-in-1?
Post by: Tuxedo3 on June 15, 2016, 02:21:40 PM
Quote from: selfdestroyer on June 15, 2016, 04:12:35 AM
I would actually move the DC jack up more.

Good advice, consider it done. Also, how tight will it be to have two boards in there?
Title: Re: How does my drill template look for a Slow Loris/Green Bean 2-in-1?
Post by: selfdestroyer on June 15, 2016, 04:12:10 PM
Quote from: Tuxedo3 on June 15, 2016, 02:21:40 PM
Quote from: selfdestroyer on June 15, 2016, 04:12:35 AM
I would actually move the DC jack up more.

Good advice, consider it done. Also, how tight will it be to have two boards in there?

Totally manageable. Just take your time wiring it up and you should be fine.

Cody
Title: Re: How does my drill template look for a Slow Loris/Green Bean 2-in-1?
Post by: EBRAddict on June 15, 2016, 05:12:31 PM
If you're using regular 1/4 jacks from Neutrik/Switchcraft/etc. they are much bigger than in the drawing.
Text only | Text with Images