im in the middle of doing this ts9 project from Aion and the clipping is confusing me
i am just doing the stock ts9-no mods, the BOM says 4 1n914 and jumper the others
doc: https://www.dropbox.com/s/b2g113hophsg3e9/aion-stratus-ts9-documentation-v2.pdf?dl=1
however in the pdf (page 4) it only shows 2 diodes in stock
this is the silkscreen, can anyone draw on for me where the diodes go for stock version. thanks
(https://s27.postimg.org/vnfpwzbfj/ts9.png) (https://postimg.org/image/vnfpwzbfj/)
The top row is D3 and D2, the next row is D4 and D5, and so on. You can see the schematic 2 diodes are stacked in series in the feedback loop, so the extra pads are provided to allow for this. If you only want 1 diode instead, connect it from the leftmost pad of D3 to the circular rightmost pad on the right.