I just finished my moodring. If you look closely you'll see an extra black wire, that's because I installed the voltage regulator backward and when I flipped it I couldn't make a great connection for V(in). So I tapped off the resistor connection to make it work.
It's a very sweet reverb. I modded the tone control for a flat response. The dwell control doesn't do too much that I notice, and I had to sub a 50k trimmer because that's all I had. I'm very happy with the build.
Artwork is by me, as usual, with envirotex on top. I messed up the ET coating the first time and had to start over from scratch. This is the 9th or so ET-coated pedal, first mistake I've made with the stuff.
The art is in keeping with an underwater theme I've been doing for a while. My phaser is the only non-aquatic themed pedal, for some reason. My original art was different and my wife (and pedal art model) recommended I go with another underwater girl.
The top:
(https://c1.staticflickr.com/1/646/32802659911_433798f8ed_z.jpg)
The guts (note extra black wire across board...grr):
(https://c1.staticflickr.com/3/2893/32083332004_29847cb22e_z.jpg)
And sitting on the pedalboards with the others. All of the non-commerical pedal art is by my except for the first one I ever did, which I used an Arthur Adams picture (the green tremulus lune).
(https://c1.staticflickr.com/1/664/32926455825_6c492b2ca7_z.jpg)
Nice job!
Wow, very very nice build, love the art!
That came out great!
Great artwork! Excellent theme going with the pedalboard.
"Real" artists always impress me. And I love comic books.
The guts look very tidy. The xtra wire just makes it looks more complex in a good way.
( I'll have to subtract a point for the solder iron burn on the green wire. ;) I've done that too many times to count )
Thanks! I was so ticked when I burned that wire. When I do the switches I'm in "hurry and play it" mode.
How do you do your art?
I'm old school. I draw it and ink with a sable brush. When I do my own art I paint with watercolor after the ink cures. For pedals I color my scanned inks in photoshop or Procreate. Then I resize the file to match my drilling guide. For the final art I print on t-shirt transfer and iron it onto the before before envirotex.
love that artwork!!!