All the projects seem to say 16v minimum on the capacitors.
Can I get away with putting two 10V electros in a pedal? (100uf value, Mandroid project)
It depends on how much voltage is on the cap at that point in the circuit. If it's in the power supply and they are seeing 9V, it's not a good idea.
How do I find out if that's the case? Or is it not worth the risk in general.
Quote from: elenore19 on September 18, 2017, 03:30:57 AM
All the projects seem to say 16v minimum on the capacitors.
Can I get away with putting two 10V electros in a pedal? (100uf value, Mandroid project)
Are you talking about C10 and C11 in the Mandroid? Those two only see a maximum of 3.6V each: the 9V is used in a split manner (it's a bit non-standard, check out the schematic), and the Zener diodes should limit what each cap gets to 3.6V max. So, 10V should be sufficient margin of safety.
Quote from: WormBoy on September 18, 2017, 09:12:29 AM
Are you talking about C10 and C11 in the Mandroid? Those two only see a maximum of 3.6V each: the 9V is used in a split manner (it's a bit non-standard, check out the schematic), and the Zener diodes should limit what each cap gets to 3.6V max. So, 10V should be sufficient margin of safety.
Those were the caps I was talking about. Thanks a bunch for the info, hopefully someday I can get the knowledge of figuring that out by myself.
Thanks again!