Here is my build. Wasn't too hard really, it's a well thought out layout. 1 small issue i had was when biasing, i cannot remember now which BBD it was but I could not bias it via the test point so i just did it direct from the 3rd pin. Happy with it.
(https://thumb.ibb.co/cZnX6G/IMG_1066.jpg) (https://ibb.co/cZnX6G)
That labeling looks really nice against that light purple. Very sharp.
Cool, liking the original look!
sick build. did you not bother with the standoff?
Quote from: LaceSensor on October 03, 2017, 11:04:15 PM
sick build. did you not bother with the standoff?
Just noticed that too. I wonder if it is epoxied to the inside like in my build.
lovely
Very nice! I like the switch handles.
Quote from: EBK on October 04, 2017, 11:53:22 AM
Quote from: LaceSensor on October 03, 2017, 11:04:15 PM
sick build. did you not bother with the standoff?
Just noticed that too. I wonder if it is epoxied to the inside like in my build.
yes epoxy