I finished the uber tuber and it sounds good but the I am getting a low reading from TP2, I am thinking I need to lower the r8 resistor but I am wondering how low I need to go.
Here are my readings;
TP1 - 11.78
TP2 - 9.92
TP3 - 11.56
TP4 - 6.22
VC - 17.97
Any help is always appreciated.
Fixed! dropped r8 down to 51k and got the following readouts.
TP1 - 11.48
TP2 - 11.10
TP3 - 11.51
TP4 - 6.21
VC - 17.97
Quote from: jjjimi84 on December 11, 2018, 10:23:35 PM
Fixed! dropped r8 down to 51k and got the following readouts.
TP1 - 11.48
TP2 - 11.10
TP3 - 11.51
TP4 - 6.21
VC - 17.97
Yup, that's fine. Like I said in the updated UberTuber doc, there is actually a fairly wide range of useable voltages the 6111 will work with. Your original 10v was a bit on the low side but might have been fine. When I tested the batch of tubes I have up for sale I was getting good results between 10v -15v on most tubes using a trimmer.
It sounded good originally but there would be something in my head that said it should be here so fix it.
I really think you hit it out of the park with this one, it sounds dynamite.
Like dy-no-mite!!!!