Ive seen some builds done in a 1590BB that have 2 stomp switches that I wish to place into a 125B but was just wondering where is best to place them. I dont want them too close to the edges of the enclosure or to squashed together, anyone got any measurements where they sit well.
Thanks
I don't have the measurements, but you don't have a lot of choice in the case of a 125b in portrait.... Basically you have to take the screw beds into account, and have the switches angled if you don't!
Yep, at the bottom and double check that you aren't too close to the bosses for the screws.
(https://i.imgur.com/MqbN2I6.jpg)
Try giving the two stomp template in the coda effects black hole build document a shot.
https://www.coda-effects.com/p/black-hole-pcb.html?m=1 (https://www.coda-effects.com/p/black-hole-pcb.html?m=1)
Quote from: benny_profane on May 25, 2019, 03:56:54 PM
Try giving the two stomp template in the coda effects black hole build document a shot.
https://www.coda-effects.com/p/black-hole-pcb.html?m=1 (https://www.coda-effects.com/p/black-hole-pcb.html?m=1)
I've used this drill template a number of times just for the stomp layout. They are well positioned and don't feel too close to the edge or together.
Sent from my iPhone using Tapatalk
Quote from: flanagan0718 on May 25, 2019, 06:17:53 PM
Quote from: benny_profane on May 25, 2019, 03:56:54 PM
Try giving the two stomp template in the coda effects black hole build document a shot.
https://www.coda-effects.com/p/black-hole-pcb.html?m=1 (https://www.coda-effects.com/p/black-hole-pcb.html?m=1)
I've used this drill template a number of times just for the stomp layout. They are well positioned and don't feel too close to the edge or together.
Sent from my iPhone using Tapatalk
Haha so have I! When I built up my black hole (very cool project, by the way) I put the LPB-1 on a switch. So, didn't use it for that project, but many others!