My latest PCB layout.
Schematic:
(https://i.ibb.co/rGxkWFw/noise-gate-schematic.jpg)
Tracings:
(https://i.ibb.co/swZpjGz/PCB-etching-raw-copy.jpg)
Component Placement:
(https://i.ibb.co/K57n4WP/PCB-with-compaonts.jpg)
Please note that we're looking at the underside, copper side of board, so the components, except for the pot, are "backward"
I used PS to do the layout, as I am very familiar with it. I color coded the nodes, then made all the tracings black. I found the learning curve of PCB design software too steep.
Any corrections, or suggestions are greatly appreciated.