I was curious if someone could tell me the values on the tractor beam bom that differ from the silk screen...my uh friend didn't see that note until after all of the resistors were soldered in.
Hey jimi
Tell your friend that it's alright and we all make mistakes ^^
I don't have any answers for you but I think we're friends with the same guy! ;D
There are two areas:
The silkscreen shows (4) 14k resistors near the level trimpot. These are 1k4 as shown on the image in the doc.
The level trimpot should be 20k, not 200k as shown on the PCB.
Everything else is the same as far as I can see.
Quote from: madbean on May 04, 2020, 04:23:25 PM
There are two areas:
The silkscreen shows (4) 14k resistors near the level trimpot. These are 1k4 as shown on the image in the doc.
The level trimpot should be 20k, not 200k as shown on the PCB.
Everything else is the same as far as I can see.
Thank you sir! My friend got everything but the trimpot. Had a 20 in there and thought it was wrong. Now gotta take out the 200.
Sent from my iPhone using Tapatalk