madbeanpedals::forum

Projects => General Questions => Topic started by: lrgaraujo on May 30, 2020, 02:38:30 PM

Title: Does anyone have tips for etching dual layer pcbs?
Post by: lrgaraujo on May 30, 2020, 02:38:30 PM
Hey guys,

I was wondering if anyone has tips for etching dual layer pcbs (mostly how to get both sides well aligned)

Thanks
Title: Re: Does anyone have tips for etching dual layer pcbs?
Post by: jimilee on May 30, 2020, 03:29:43 PM
I didn't k ow that was a thing. I'm interested in the answer too.


Sent from my iPhone using Tapatalk
Title: Re: Does anyone have tips for etching dual layer pcbs?
Post by: davent on May 30, 2020, 03:37:33 PM
A few old threads at diystompboxes...

https://www.diystompboxes.com/smfforum/index.php?topic=91920.0

https://www.diystompboxes.com/smfforum/index.php?topic=113924.msg1056118#msg1056118

https://www.diystompboxes.com/smfforum/index.php?topic=79338.msg654523#msg654523
dave
Title: Re: Does anyone have tips for etching dual layer pcbs?
Post by: thomasha on May 30, 2020, 03:47:14 PM
My first try was aligning the two pieces of paper with the layout against the light and taping the edges just far away enough so that I could slip the PCB inside. It worked nicely.
(https://i.imgur.com/MJlRNYgl.jpg)
(https://i.imgur.com/wbLzbZsl.jpg)
Here you already see the connections from one side to the other.
Since it was also my first one, I kept changing sides around the main components to accommodate all the parts as close as possible. But, as you can see, they align pretty well for a small board.
(https://i.imgur.com/cZBdhahl.jpg)
This one is just for reference. Lots of pretty small smd stuff there.
Title: Re: Does anyone have tips for etching dual layer pcbs?
Post by: lrgaraujo on May 30, 2020, 03:57:42 PM
Thanks for the tips, guys

Will report back when I have some results