Print Page - [SOLVED]Glasshole - everything works, but the D2 the LED for the photoresistors!

Title: [SOLVED]Glasshole - everything works, but the D2 the LED for the photoresistors!
Post by: BeeSharp on August 29, 2020, 10:55:15 PM

Hi,

I just finished building the Glasshole, everything works (I think), but the LED for the photoresistors (D2). The pulsing LED's and the indicator. The photoresistors seem to work because when I raise the pedal off the floor (and allow light in), it makes a phasing sound - this is without the light shield and enclosure bottom plate attached.

I have had an LED from Tayda go bad or just be a dud. I didn't check it before I installed it and - F! lesson learnt.
(http://i.imgur.com/ATpbVdm.jpg) (https://imgur.com/ATpbVdm)

Title: Re: Glasshole - everything works, but the D2 the LED for the photoresistors!
Post by: madbean on August 29, 2020, 10:57:31 PM

You need to jumper the external jack pads as shown in the Notes section. Should work after that.

Title: Re: Glasshole - everything works, but the D2 the LED for the photoresistors!
Post by: BeeSharp on August 30, 2020, 02:17:24 AM

Thanks for the help and sorry I missed it. I skipped over the tap section. That fixed it!

madbeanpedals::forum

Projects => Tech Help - Projects Page => Topic started by: BeeSharp on August 29, 2020, 10:55:15 PM