I ordered parts for the mudbunny when I have the pigbutt, guess I'm just going to have to order the mudbunny board earlier. ;D
So before I make another mistake, I've ordered some parts and thought I'd use some I had for the triplet and want to make sure the value won't change the pedal too much or ruin it.
65k Metal / Carbon Film 1/8W (3) using 68k as sub, a few others I used 1/4W and I don't think those will make a difference other than poking up from the pcb a bit.
Anyone know if it will make a difference being 3k more than listed in the BOM?
3k in this instance is less than 5% off. Certainly within the tolerances of the original parts. You should hear no difference.
Quote from: Betty Wont on May 27, 2021, 04:11:02 PM
3k in this instance is less than 5% off. Certainly within the tolerances of the original parts. You should hear no difference.
Awesome, I was concerned because it is part of the octave circuit.
Glad to know I can move forward and only need to order the parts I missed on this project and a few others, since I haven't soldered the mainboard I might try again on mouser with finding 1/8w where I am subbing 1/4w.
Thanks!