madbeanpedals::forum

Projects => General Questions => Topic started by: Hefty on May 28, 2021, 02:04:30 AM

Title: Krypton Phaser
Post by: Hefty on May 28, 2021, 02:04:30 AM
I just finished a Krypton Phaser from Elemental FX sounds good  but get loud pop when I hit stomp switch.  I thought maybe I would try opto board and momentary switch but ended up still with pop on switching. Is this a common problem with this build or did I miss something?
Title: Re: Krypton Phaser
Post by: jimilee on May 28, 2021, 02:05:57 AM
None of mine have a pop. I think I have 3 or 4 different ones including the duophase.


Sent from my iPhone using Tapatalk
Title: Re: Krypton Phaser
Post by: Hefty on May 28, 2021, 02:09:34 AM
any idea why I get the pop
Title: Re: Krypton Phaser
Post by: Hefty on May 29, 2021, 05:14:58 PM
found my pop, I had the 3 legged LED just pushed into the pcb, trying to decide if I was going to install the led for the flashing effect. As soon as I soldered it in, pop went away. This is a nice sounding pedal. A fun one to build for sure.
Title: Re: Krypton Phaser
Post by: jimilee on May 29, 2021, 05:16:33 PM
Quote from: Hefty on May 29, 2021, 05:14:58 PM
found my pop, I had the 3 legged LED just pushed into the pcb, trying to decide if I was going to install the led for the flashing effect. As soon as I soldered it in, pop went away. This is a nice sounding pedal. A fun one to build for sure.

Nice job. Enjoy!
Title: Re: Krypton Phaser
Post by: Hefty on May 29, 2021, 05:20:29 PM
Thanks again for the quick help and replies