I'm finally getting around to building my Springboard. At the top left of the board it's labeled with a 500k trimpot and 2 100k resistors. But the component list and the schematic both call for a 5k trimpot and 2 1k resistors, which I'm planning on going with. Didn't see anything on the Springboard page that says otherwise. I'm assuming it's just a misprint on the board. Anyone help me on this? Thx
There's actually a note about that on pg.2 of the build doc:
Note: Use the values listed on the image above not the values indicated on the silk-screen of the PCB. Some values changed over time in the VFE product cycles.
Gotcha, totally overlooked that. Thanks for getting back so quickly.