Print Page - 2-in-1 Wiring Question

Title: 2-in-1 Wiring Question
Post by: thetrend77 on January 25, 2012, 07:16:33 PM

I found a diagram for wiring 2 effects in one enclosure, but is it possible to wire a 2-in-1 using gtr2(Josh)'s 3PDT boards?

These: (http://farm8.staticflickr.com/7141/6722781857_cb645b3e61_z.jpg)

I'd like to be able to use those to cut down on the wiring inside my enclosure. If it's possible can someone please draw a diagram for me? Oh and the 2 effects I'm putting in an enclosure are both on vero, if that makes any difference. Thanks!

Title: Re: 2-in-1 Wiring Question
Post by: jkokura on January 25, 2012, 07:30:14 PM

It's really simple. Whenever you do a 2 in 1 pedal, you treat each pedal as sperately wired but wire the 'out' of the first switch to the 'in' of the second. So in the case of Josh's boards, on the left there were it says "OJ", connect those two pads to the "IJ" on the second switch. Done.

Title: Re: 2-in-1 Wiring Question
Post by: thetrend77 on January 25, 2012, 07:31:20 PM

Tip to Tip, Sleeve to Sleeve?

Title: Re: 2-in-1 Wiring Question
Post by: jkokura on January 25, 2012, 07:52:10 PM

yep!

Jacob

Title: Re: 2-in-1 Wiring Question
Post by: thetrend77 on January 25, 2012, 08:16:19 PM

Awesome, thanks!

Title: Re: 2-in-1 Wiring Question
Post by: thetrend77 on February 03, 2012, 12:42:52 AM

I actually started working on this tonight and I have another question...

Which one of the wiring boards do I wire the DC jack to? Or do I run wires to both?

Title: Re: 2-in-1 Wiring Question
Post by: sgmezei on February 03, 2012, 06:49:49 AM

both please ;)

madbeanpedals::forum

Projects => General Questions => Topic started by: thetrend77 on January 25, 2012, 07:16:33 PM