Print Page - Adding a Volume Pot to the Sqweeker Circuit?

Title: Adding a Volume Pot to the Sqweeker Circuit?
Post by: marginwalker on March 15, 2012, 10:28:47 AM

Hey everyone, I'm a total noob at DIY pedal building and was wondering how to go about adding a volume pot to the Sqweeker circuit? Also, what value pot should I use?

thanks!

Title: Re: Adding a Volume Pot to the Sqweeker Circuit?
Post by: madbean on March 15, 2012, 11:11:04 AM

Welcome to the forum!

Easy enough. Use a 100kA pot. Solder one wire to each lug of the pot. Lug3 gets wired to the OUT on the circuit board, Lug1 should be wired to ground (wherever is convenient, either on the PCB, or on one of the jacks or switch) and lug2 is the new output---that gets wired to the 3PDT switch where the original OUT would have gone.

That's all there is to it.

Title: Re: Adding a Volume Pot to the Sqweeker Circuit?
Post by: marginwalker on March 15, 2012, 04:53:06 PM

thanks very much madbean! i cannot wait to get all the parts in to get this going!

madbeanpedals::forum

Projects => General Questions => Mods => Topic started by: marginwalker on March 15, 2012, 10:28:47 AM