G'day to all Matt here. I was hoping someone might offer some advice on a vero tonebender that i've recently made and she's a dud. I have used a voltage convertor board that called for a icl7660 and i've used a tc7660, would that make a difference? Also there is a wire that comes off a pot that goes to +ground, i've connected that to the input sleeve, is this correct? Any advice appreciated. thanks, Matt.
snap a pic and post that with the plan.
vero is easy and fun however the layout is very easy to mess up.
do your battleship counts again and check all the polaritys
Sorted it out, but thanks for the reply mate, Matt.