Hi, having seen a few builds being done lately... the 2 in 1 enclosure syndrome, I am interested in putting a Faultline, Pork Barrel and Roadrage in the same enclosure.
Can anyone do me a schematic to illustrate how I can do it??? I want to be able to switch it so I just have the Faultline seperate as well.
I have an idea how to do it...But.. Hmmm, I don't want to mess up the builds, I would rather have somebody with a bit more experience on pedals just to nudge me in the right direction... Thanks.
It's really quite simple in that you build 2 pedals independently,take the out of one effect to the in of the next effect where your jacks would normally be. What are going to do with the roadrage?
Hmmm, the Roadrage is the part that is bothering me. Its for the Faultline, the docs say its Vol and Gain is better with 18v so I built the Faultline with that in mind all caps are 25v and some 63v.
I was thinking taking 9v from the Dc jack to the Roadrage which generates 18v which then goes to the Faultline... that would all be on bypass SW1
Then take 9v from the DC jack to the Pork Barrel which would be on Bypass SW2.
I have found a diagram for wiring two fx in one box so does all that sound feasible??
just take a 9v tap from the roadrage to the other PCB...
mind you the pork barrel, if you can get MN3007 chip, sounds much better at 15v...
Id be tempted to run the Faultline at 18v, but have another tap going to a second 15v regulator on a bit of vero to power the pork barrell
ignore this if you are building the 3207 pork...
This is how I would do it
optional 15v in pink...
What am I like...Duh, I have built the Pork Barrel with the Mn3007 so your diagram will sort everything out.
I take it the extra 15v reg will help with the current draw ...meaning I shouldn't try and run both fx with one Roadrage even when it has 18v and 15v outputs.
Well thanks very much for your time on this Lace...Appreciated :)
Quote from: fendman on January 24, 2013, 04:13:58 PM
What am I like...Duh, I have built the Pork Barrel with the Mn3007 so your diagram will sort everything out.
I take it the extra 15v reg will help with the current draw ...meaning I shouldn't try and run both fx with one Roadrage even when it has 18v and 15v outputs.
Well thanks very much for your time on this Lace...Appreciated :)
Not sure, I assumed you used on or the other out 15/18v not both... Could be wrong...
Check the current draw of the fx you are boxing, might be fine...
Eventually have got the Faultline working...one of the Fet's Q6 was defunkt and there were one or two solder bridges, anyway I measured the current draw to be 7.8 milliamps, so that will leave me 12milliamps for the Pork Barrel .
I am waiting for some parts so when I get them I will see what the current draw is on the Pork barrel..unless anyone knows.
Current Draw might be a good addition to have on Build pdf it is useful if you are thinking of putting builds together and using the Roadrage.