Hi there!
I need advice with my klon Project, im with the etching versión, but following the diagram i soldered the c6 cap, and in the layout i see a jumper ¿?=¿ between r 8 and r9 ¿? ??? ???
So what i should do?? leave the cap there or remove and jump it?
any help wellcomed!!
DO you have a link to the layout you are using? There are a few of them out there.
http://www.madbeanpedals.com/projects/Sunking/docs/Sunking_ver.3.pdf
from page 5 .. thnx !!
Leave the cap, but you need to put that jumper in. Shouldn't interfere, so go ahead.
Jacob
thx