Project: Stage Fright
Issue: Signal going through unaffected. Speed LED works great.
5/6 switch to the right.
Speed and Balls about halfway.
The only sub is for R48. I used 2.7k instead of 3k.
Voltages:
At power source: 9.16v
Three random spots:
Switch lug next to "5/6": 2.233v
R27: 4.42v and 5.58v
C3:4.57v
IC1:
1.going nuts
2. 4.54v
3. going nuts
4. .3mv
5. 4.58v
6. 4.58v
7. going nuts
8. 9.16v
IC2:
1. 4.58v
2. 4.58v
3. 4.17v
4. 9.16v
5. 4.56v
6. 4.58v
7. 4.58v
8. 7.56v
9. 4.58v
10. 4.5v
11. .4mv
12. 4.56v
13. 4.58v
14. 4.58v
I can't find any sort of pattern in these, like I thought I would. I can only describe these as bat shit insane.
IC3:
1. 104.2mv
2. 130.2mv
3. 4.58v
4. 4.5v
5. 122.5mv
6. .2mv
7. back and forth between 120mv and 160mv
8. 2.266v
9. 2.244v
10. -94.5mv
11. 9.16v
12. -191.6mv
13. 4.41v
14. 4.58v
15. 97.5mv
16. 100.9mv
IC4:
1. 86.8mv
2. 275mv
3. 4.58v
4. 4.42v
5. -118.3mv
6. 0
7. -127.8mv
8. 2.24v
9. 2.23v
10. -149.7mv
11. 9.16v
12. -135.4mv
13. 4.42v
14. 4.58v
15. 40.2mv
16. 42.8mv
IC5:
1. 79.1mv
2. 64.5mv
3. 4.58v
4. 4.41v
5. -29mv
6. .3mv
7. -95mv
8. 2.244v
9. 1.591v
10. goes from -80mv to -270mv
11. 9.16v
12. -212.2mv
13. 4.39v
14. 4.58v
15. .5mv
16. 1.9mv
So, eh...what's up?
Answer: Jumper the CV.
(http://i.imgur.com/uwEYtCL.jpg)
(http://i.imgur.com/NXMmJke.jpg)
Crap.
I didn't jumper the CV.
Well, notice anything else amiss while this is up here?
Ever get this figured out? Mine's doing something similar...
Yeah, I didn't jumper the CV.
Check that out.
Yeah, I neglected that step as well... but still having problems. I'll do some debugging and post a thread if I can't figure it out. Thanks!