Print Page - Schematic for cross over circuit to split high / low guitar input

Title: Schematic for cross over circuit to split high / low guitar input
Post by: arthurc on July 16, 2014, 07:23:23 PM

Does anyone have a schematic for a circuit that would divided hi/lo freqencys after the input buffer to process seperately until mixed again at the end of the effect? I could see this as being very useful in serveral modulation projects im dreaming up. Any help would be apprecaited.

Title: Re: Schematic for cross over circuit to split high / low guitar input
Post by: kothoma on July 16, 2014, 10:20:46 PM

Something like this? http://diy.thcustom.com/shop/pro-cessor-v4-0-pcb/

Title: Re: Schematic for cross over circuit to split high / low guitar input
Post by: oldhousescott on July 17, 2014, 06:14:04 AM

Craig Anderton's QuadraFuzz circuit (http://www.paia.com/ProdArticles/quadrafz-design.htm) might give you some ideas. Looks similar to the concepts in Thomas's board.

Title: Re: Schematic for cross over circuit to split high / low guitar input
Post by: arthurc on July 17, 2014, 06:36:25 AM

Thank you both, i'll check both of those out. My "wheers" are already turning. <-insert evil grin here :D

Title: Re: Schematic for cross over circuit to split high / low guitar input
Post by: juansolo on July 17, 2014, 07:44:16 AM

Yup: http://www.madbeanpedals.com/forum/index.php?topic=16546.0

madbeanpedals::forum

General => Open Discussion => Topic started by: arthurc on July 16, 2014, 07:23:23 PM