madbeanpedals::forum

Projects => Build Reports => Topic started by: Guitarmageddon on November 15, 2014, 03:41:30 AM

Title: Woody-Vibe & (another) Supro
Post by: Guitarmageddon on November 15, 2014, 03:41:30 AM
The "Woody-Vibe."
MB Harbinger, Woodstock etch. Runs on 9vDC useda darlington at Q13 works great.



Light shield is a replacement toner cartride plug for my cannon printer, usually I use the metal top off a champagne enclosure, (prefer Marlborough region NZ wines, when possible...) but this as a bit tight in a 125BB so I went with something non-conductive.





Supro (ROG suprodeaux)



I get asked to build these a lot, great circuit and I'll only do it on these beautifully designed licenced boards
(possibly the first I'd seen with test points?- pretty cool idea!), anyway,I'm down to my last one. Pick them up second hand whenever I see them- if you've got 10 or so , message me! :D

Title: Re: Woody-Vibe & (another) Supro
Post by: cooder on November 15, 2014, 04:09:31 AM
Superb Ben, your etches are awesome and the inside rocks! Very cool! 8)
Title: Re: Woody-Vibe & (another) Supro
Post by: diablochris6 on November 15, 2014, 03:49:07 PM
Great job, as usual. The beauty of that Supro etch never gets old. That exact PCB was my gateway into pedal building. Those transistor pads are a lifesaver.
Title: Re: Woody-Vibe & (another) Supro
Post by: Jakes Dad on November 15, 2014, 06:19:46 PM
Both these are great inside and out.  Love the simple yet creative etches.

Chuck