I've been reading through the posts on voltage readings etc for the multiplex from 1776 but did not find one that sort of addresses my issue (unless I missed it if so sorry for the repeat post). I can only get to 0.36v and my 2k trimpot is maxed out. The LED stays dim if not at all. I did notice when I first powered up the led was bright and the voltage was well over 5v so I let it discharge and tried again very slowly. Now it peaks at 0.36v. Any suggestions?. I let it discharge again and started over but ended up with the same results.
Thanks Pete...***** Little more reading through posts in here and found my answer. Worked like a charm.
Glad you were able to find a solution :)
Josh
Thanks Josh, just waiting on a foot switch to arrive so I can test it out then it go's into a multi effect enclosure along with a Moodring reverb pedal. Ambient clouds await : )
Quote from: pogart on February 12, 2015, 02:26:38 AM
Thanks Josh, just waiting on a foot switch to arrive so I can test it out then it go's into a multi effect enclosure along with a Moodring reverb pedal. Ambient clouds await : )
Sounds like a killer build!
Josh
I'll post some pics when I have it all ready to roll.