I built this with an MN3207 that I had left over from a flanger build. I originally ran the wires form the jacks to the switch directly under the board. This resulted in prominent ticking. I rerouted the wires along the left wall of the enclosure and the ticking went away completely
(https://live.staticflickr.com/65535/49062303733_0638963aca_c.jpg) (https://flic.kr/p/2hKt8Av)
I drew the frog by hand in pencil, then scanned it and touched it up in Gimp. The lettering is my engineer's print that I scanned and cleaned up as well.
(https://live.staticflickr.com/65535/49062817721_6c977a2101_c.jpg) (https://flic.kr/p/2hKvLon)
If you look closely, you can see where I burned through the powder coat while polishing the clear coat. I've done this on enough builds that I'll be experimenting with refinements to my finishing process. I hate paying extra for a powder-coated enclosure and then distressing it.
(https://live.staticflickr.com/65535/49063035452_9331f7e84f_c.jpg) (https://flic.kr/p/2hKwT7m)
I may increase the speed of the LFO some day, but I actually think slower rates suite this waveform (triangle?) better than they would a traditional vibrato. Vibrato mode yields more of a "warped vinyl" sound than a traditional vibrato sound. On the whole, I'd say the "Mix" control does make the effect more versatile; you can use high rate and depth and dial back the mix to avoid the sea sick sounds.
Super clean! I really like the handmade details like the art and text. Great job!
Quote from: selfdestroyer on November 17, 2019, 07:55:53 PM
Super clean! I really like the handmade details like the art and text. Great job!
Thanks! I haven't drawn in forever. I almost forgot I could.