madbeanpedals::forum

Projects => General Questions => Topic started by: redkurn on July 21, 2021, 10:52:32 AM

Title: Mudbunny general question
Post by: redkurn on July 21, 2021, 10:52:32 AM
Iíve been enjoying this pedal a bit since I built it a week or so ago, but the sustain knob seems to from 0-100 at 1 and 1000 dimed out.

What resistance pot would give it more range without losing much of the stock half way point or is it supposed to be an untamed beast? XD

I followed the standard build guide.
Title: Re: Mudbunny general question
Post by: jimilee on July 21, 2021, 10:59:04 AM
Iíve been enjoying this pedal a bit since I built it a week or so ago, but the sustain knob seems to from 0-100 at 1 and 1000 dimed out.

What resistance pot would give it more range without losing much of the stock half way point or is it supposed to be an untamed beast? XD

I followed the standard build guide.

Are you using a log or linear pot now? Log will go slower than a linear.
Title: Re: Mudbunny general question
Post by: redkurn on July 21, 2021, 05:26:29 PM
The one Brian listed in the bom.
Itís log I think.
Title: Re: Mudbunny general question
Post by: jimilee on July 21, 2021, 05:32:14 PM
The one Brian listed in the bom.
Itís log I think.

Nope, Linear (B) is listed in the BOM. You can switch to Log (A) and it won't turn up as quickly.
Title: Re: Mudbunny general question
Post by: redkurn on July 22, 2021, 12:42:55 AM
I got to use it on a different amp and I think the knob for sustain is pretty good, but I may change it over to a log so I can get a little more control from it.

Never did I imagine I could get a solid 5+ minutes of sustain going. XD it just doesn't seem to stack very well after the rat(SlowLoris2020) unless the sustain is turned down to almost nothing.

Cool pedal.