Hi all,
I'm soldering an old firebomb pcb and I noticed in the documents that R1 and R10 aren't listed in the BOM but they are on the layout diagram. They are also not listed on the schematic. I have put photos below.
I noticed that they are immediately after the input A and B, and when looking through the krankosaurus and kokbox schematics they have a 1M resistor immediately after the input. Would I be safe to assume that these resistors will be 1M too?
(https://imgur.com/a/LIEJmNN)
(https://i.imgur.com/ixO4C5h.jpeg)
(https://i.imgur.com/wdM8mQW.jpeg)
Yes, they should be 1M's.
Thanks mate