Hey what are you guys using for Transistor sockets? Part numbers from wherever would be great.
Thanks.
I just use SIL (single in line) sockets and cut them to fit my layout.
But you can get tranny sockets HERE (http://www.effectsconnection.com/oscommerce/product_info.php?cPath=37&products_id=505) and HERE (http://www.smallbearelec.com/Detail.bok?no=147).
Good deal, thanks! I was wondering about the inline ones. I am going to build a Sunking and I'm fairly new at soldering and I didn't want to fry my transistor but those round ones don't match up with the holes on the Sunking board...so go with the inline? Are they low profile enough?
Oops! I mis-spoke. I meant the Fatpants. Total noob!
That's why CRBMoA suggested the inline SIL ones.
Here's Smallbear's link: Http://www.smallbearelec.com/Detail.bok?no=101
They're out there for less money, but that's just one option.
Jacob
Get an 8 pin socket for the IC too. Those are actually even more sensitive to heat than the transistors from what I understand.
Perfect, thanks guys.