HI all-
I just pulled out a very old build of the Boneyard. It's the one with the very small rectangular PCB, with beveled upper corners and square lower corners. I'm interested in getting it working again. The switch wiring is kind of complicated. I looked at instructions for what is supposed to be V1, but mine is older than that! The ground leg of each LED is soldered to the upper right lug on each switch (as you look down on the guts), but I cannot figure out how they get power. There are other random wires loose that I don't know how to reconnect. I'm not an electrical engineer, but I follow directions well. Does anyone have the instructions or a switch wiring diagram for a very early version of Boneyard? I know this one was discontinued because of noise issues, but I recall mine working fine once upon a time. I'd love to put it back in service.
I just pulled out a very old build of the Boneyard. It's the one with the very small rectangular PCB, with beveled upper corners and square lower corners. I'm interested in getting it working again. The switch wiring is kind of complicated. I looked at instructions for what is supposed to be V1, but mine is older than that! The ground leg of each LED is soldered to the upper right lug on each switch (as you look down on the guts), but I cannot figure out how they get power. There are other random wires loose that I don't know how to reconnect. I'm not an electrical engineer, but I follow directions well. Does anyone have the instructions or a switch wiring diagram for a very early version of Boneyard? I know this one was discontinued because of noise issues, but I recall mine working fine once upon a time. I'd love to put it back in service.