Messages

  Yes it may fit in 1590G, dimensions of PCB are 69x39mm but momentary foot switches must be smaller 

Thank you very much Marshall
I did not read carefully
You have very interesting projects and looking forward to it AVR ATtiny 85, 24 and 13 do the most things I need in my projects and planning to adapt Taprecise to one of them  I have already projected and tested PCB for Taprecise in SMD  If you like I will send you project, privately, made via Easyeda because people ask you for PCBs and this one is reduced size.

  I uploaded code  Version 1.0 and it works fine so far. No modulation disappearing after changing tap tempo
It seems to me that Version 1.0 code is more suitable for single PT2399 delays
Are there any staffs in 1.2 main code improved for single PT delays, maybe to copy in 1.0 version main code? I saw different limits for modulation in ver 1.0 from 10 to 245 and in ver 1.2 240 to 250 (245 average) which is better conception?
All the best

Yes I will do it tomorrow. I started with original one few days ago version 1.2. I use 50k digipot and calibrated it with 250 not 160 with max delay time of 600ms. Mayby to try main code 1.0 2016? It seems to me that something stops mod signal on pin 9.

Hi Guys 
I have built TAPRECISE with Deep Blue Delay and everything works excellent but modulation.
At the beginning  after turn power on modulation works fine but immediately after change tap tempo both by tap tempo momentary foot switch or by rotary encoder (fine tune delay) modulation disappear and delay continue to works fine  without mod. I tried to change values in main code to increase modulation 150-255 and always the same, mod stops after change tempo. Modulation starts after unplugging and plugging power cable.
Please help if the problem is in the code or elsewhere 
All the best and happy holidays