Hello,
i just built a Lectric's Pork Rind . At the first hit it has no proper sound but it sounds low gained and fuzzy. After a couple of times that i played with it stopped . I check everything with multimeter , the components and the cables, conductivity etc... They are ok . The possible mistakes that i did were : 1) i place 1,2kOhm resistors instant of 1kOhm . 2) I placed this trimmer [ https://grobotronics.com/trimmer-10kohm-multiturn-vertical.html ] that could be wrong . Is any of these two a critical mistake for the function of the circuit ?
Thanks a lot, Romanos
i just built a Lectric's Pork Rind . At the first hit it has no proper sound but it sounds low gained and fuzzy. After a couple of times that i played with it stopped . I check everything with multimeter , the components and the cables, conductivity etc... They are ok . The possible mistakes that i did were : 1) i place 1,2kOhm resistors instant of 1kOhm . 2) I placed this trimmer [ https://grobotronics.com/trimmer-10kohm-multiturn-vertical.html ] that could be wrong . Is any of these two a critical mistake for the function of the circuit ?
Thanks a lot, Romanos