Messages

That would be great

Wondering if a ABY pedal (w/tranformers) would be of any interest to anyone
I see that GGG had one but I dont see the PCB for sale anymore
is this something that could be done?

Thanks guys
really appreciate it
will try to get clips as soon as I can
I told myself I would take a break from pedals for a while....
next day I ordered 4 more boards...
I'm not hooked....I can stop anytime....Right?

Have not used many Dist pedals... but this one really
kicks butt...Boost is nice too...still tweaking to get them both to sound good together...
separately very nice...inspiring sounds with a Princeton Reverb

I did sub the 22n/C1 mod as per pauloman80 in the Mod section
http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/Krankosaurus/krankosaurus006.jpg
Thanks Madbean

On to the next one....

Thanks for the info Jacob
I will try to wrap my head around your wiring
...so resistor is on top middle lug,also
thinking the right middle lug is used to go to the other switch(Krankosaurus)
thanks for your time


pauloman80
I was hoping for a "resistor on the switch solution"
it looked nice and clean...bummer it doesn't work
thanks for your time

Thanks jkokura
that would be great

Hi guys
wondering if this will work if I change the resistor to A2 and A3?(per madbean)
if so does the ground need to still go from A3 to B3?
any suggestions are greatly appreciated
Thanks





[attachment deleted by admin]

Using a Fender Princeton clone and a LP
1st impression...if I can get it dialed in I may like it a little better than my Serendipity
for that subtle mid growl.
Will try it with a 2 el84 liverpool clone and Strat next
this one is a keeper

Maysink
Thanks again for taking the time to straighten me out..
really appreciate it

maysink said:

Wait. What happened to R6 & R10?

Thanks maysink you made may week
installed R6 R10 reflowed and bam that was it...
going to clean up the wiring and run it thru some tests
you are the man in my book..
hope I can return the favor someday
thanks again

Guess I'm ordering some IC's 
some more pics


http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/Mysterioso/mysteriosojr007.jpg

http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/Mysterioso/mysteriosojr005.jpg

any comments or suggestions are greatly appreciated

Thanks

Will check for bridges again
could it be  bad 072 or 4049?
or would it still make noise

I'll post more pics ASAP

Thanks

Jumper is installed
Diode is right direction
continuity checks out on switch

Sorry guys
checked and rechecked
wondering if anyone sees something wrong besides that I put the power jack on the wrong side

http://i1018.photobucket.com/albums/af301/dcribbs1412/pedals/Mysterioso/mysterioso1.jpg

wondering about the switch....bypass works


any help is greatly appreciated

I'm in
would be great to use 12a_7's
kind like this one?


[attachment deleted by admin]

Congrats on a very nice build
on with the next one