Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - giock

Pages: [1]
How Do I? Beginner's Paradise. / Re: LT1054 and wires
« on: March 17, 2019, 11:45:03 PM »
Thnks you guys, as i tell you i'm really noob...
I understand that i'm going yo make a mistake, i read again the zirconia instruction... my english is not so good and technicals made translation hader. They suggest to use the LT1054 as IC1 in the 3PRR (the once i called pss3 ;D) because of the power consumption of the VTL5C3,
at the first reading I understood to exchange them but thanks to your considerations I understood that they are not the same components ;)
Ok, so... AWG24 and LT1054 8 pin through-hole the cheaper ;)

How Do I? Beginner's Paradise. / LT1054 and wires
« on: March 17, 2019, 12:29:41 PM »
Hi everyone, my first post to greet you and have a couple of clarifications.
Part one, presentation:
I am a singer and bass player, I am quite an expert on electricity (I am an auto electromechanical) but I am absolutely noob to electronics: pcb, cap, res, trick track etc ...
I decided that my first quest in this DIY world will be an optical compressor: Zirconia (for bass)
Part two, clarifications:
what kind of wire do you recommend using in connections? AWG22? 24?
In zirconia for bass it's recommended to use the pss3 so my vactrol will be the LT1054 but there are 4 versions !!!
the LT1054IP
Which one should I take ???
Thank you

Pages: [1]