It's not easy to assemble as the spacing is not much, I had to check the wiring quite a bit, but the v.2 of the pedal I have is all correct in the end.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Build Reports / Re: BOSS CE1 PROJECT: MN3002 or TDA1022P: DOC UPLOADED
September 06, 2021, 08:35:14 AM #2
Build Reports / Re: BOSS CE1 PROJECT: MN3002 or TDA1022P: DOC UPLOADED
September 06, 2021, 03:24:19 AM
Quick update on this. I bought new chips and the pedal now works!
I just had a fake Chinese version. Watch out people! The pedal sounds great though, it's a great project.
I just had a fake Chinese version. Watch out people! The pedal sounds great though, it's a great project.
#3
Build Reports / Re: BOSS CE1 PROJECT: MN3002 or TDA1022P: DOC UPLOADED
August 28, 2021, 08:24:14 AM
Hi everyone, I've finished the king of chorus v.2 but it's not working. How likely is that I have a bad/fake TDA1022P?
The pedal powers on, leds work, I can only hear the guitar but with no effect. I also notice a very low amount of distortion in the background when it's on. Wiring and soldering are right and components are correct. The 'volume' and 'rate' pots work.
Is it worth trying a new 1022P chip?
Thanks
The pedal powers on, leds work, I can only hear the guitar but with no effect. I also notice a very low amount of distortion in the background when it's on. Wiring and soldering are right and components are correct. The 'volume' and 'rate' pots work.
Is it worth trying a new 1022P chip?
Thanks
Pages1