News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - pedalman

#1
VFE Projects / Relay question
March 27, 2019, 05:24:06 AM
I had a few of these laying around. Will they work on the pinball ?
#2
You live in UK?  Jump on thomann and grab one of those t.c. electronic honey pots. Thomann has them for twenty-something bucks.
#3
Quote from: TNblueshawk on February 22, 2019, 08:38:50 PM
Quote from: pickdropper on February 22, 2019, 07:18:36 PM
Quote from: davent on February 22, 2019, 05:45:11 PM
You can also get nylon/plastic hole plugs in various diameters that are very low profile and snap into the hole. Good for a spot that may not need nearby redrilling, makes it look like a hole that will come into play for a future option, planning ahead.
dave

Or you can leave them open as tone ventsTM

Nice. I never thought of a ported pedal. That would let the caps breath a little.

Wouldn't all the electrons fall out ? Jeeze.....
#4
Open Discussion / Could be interesting
March 23, 2019, 04:57:33 PM
This could be interesting
#5
Dog food scoop
#6
Think of pad 1&3 as a flowing river
Pad 2 is the bucket scooping up water
#7
VFE Projects / Pinball question
March 16, 2019, 08:25:51 PM
I want to build a pinball so it can be used as it was designed. But was wondering if I could add a loop as well. Let's say I want to modify only a big buff in a petalboard arrangement. Should the loop be on the eq, or the muff?
#8
Open Discussion / Re: Plexiglass
March 14, 2019, 10:30:14 PM
Yep, that's what I'm looking for
#9
Open Discussion / Plexiglass
March 14, 2019, 08:17:23 PM
I've seen plexiglass spacers on some of the enclosures (under the lid)
Does somebody make these, or are they a custom made thing?
#10
Open Discussion / Re: Fart'n around at the bench
March 08, 2019, 04:18:59 PM
It was supposed to be a graphic etch test  but the paper failed
#11
Back in the day, Blue Diamond Almond made short stubby cans. Perfect for hardware.

Everybody also had the revolving baby food jar wheel of doom
#12
Desolder a radio shack pcb and you will see exactly what Brian is talking about. Lol
#13
EEV blog does a bunch of cheap reviews

Otherwise I usually trust Circuit Specialist
#14
Open Discussion / Fart'n around at the bench
March 08, 2019, 08:24:12 AM
I was trying out some new printer paper for enclosure etching. Turned out a huge failure, but I had all the gear out for messing around with salt solution so I started playing around with that like a mad scientist with a arc welder

Test 1 was a 6v battery and that was a joke (slight fog)

Test 2 I snapped 2, 9v's together and hit it. This time i masked off a area to see a definite line

At this point I was ready to clean up and go towards a copper sulphate solution tomorrow.
I look over and see soy sauce on the counter.  Hmmm

Test 3, 18v & soy sauce. Believe it or not, it had the best reaction so far and a little quicker.

Tomorrow the copper sulphate comes out along with bench power
#15
I use this a lot, throw in a LCD and your pimp'n it