Hello, PCB'S are finished, holes are drilled. Now I am stuck!
I am not an electrical engineer, The only thing I have done in relation to electrical, is soldering..Therefore I can not read the schematic to finish the wiring.. I was wondering if anyone had pictures or a 3D diagram of the finished unicorn buffer with and without a stomp switch. Also, the pictures I did find online did not show which of the 3 prongs on the input/output jacks was the POWER/GROUND/NEUTRAL ETC. Which one do I solder to for ground?
Thanks guys!
I am not an electrical engineer, The only thing I have done in relation to electrical, is soldering..Therefore I can not read the schematic to finish the wiring.. I was wondering if anyone had pictures or a 3D diagram of the finished unicorn buffer with and without a stomp switch. Also, the pictures I did find online did not show which of the 3 prongs on the input/output jacks was the POWER/GROUND/NEUTRAL ETC. Which one do I solder to for ground?
Thanks guys!