Topics

Not really a fan of the Ruetz mod so if I want to not use the sweep pot, do I just put a 1k resistor across pins 1 & 2  or do I put a jumper across 1 & 2     

If you liike good warm octave fuzz with some serious sustain, this is the one.

I've tried several methods and so far this has been the most organized and easiest to use. Capri Sun FTW !!!

If I want to use default clipper in the ego driver so I just jumper holes 1 and 2 on the clip switch and omit the D4 and D5 LEDs ?

Finally got around to builing my Sunking board I got in a recent trade..  I think it came out great and it sounds every bit as awesome as I expected.

Buillt my Poker without any substitutions. I used the 3201 / 3207 chips.

I get a good bypass and when I engage the 3pdt I get the same a clean guitar signal.  No chorus effect.  My LFO is flashing.

Taking voltages on the ICS they look pretty much in line with other posts in the section except for the 3207.  My readings are:

1-0
2-3.72
3-4.04
4-7.45
5-0
6-3.63
7-0
8-0

I'm pretty sure pins 5 - 7 are not correct   but not sure where to look from here.  

I have reflowed the socket and the jumpers and parts around IC4 but I am not really sure where to look ?

I noticed on the new boards like the Slow Loris and PepperSpray the 9v connector now has a pos and a neg pad ?  Is the neg just an extra ground ?

Logged on today to buy a couple of Slow Loris boards and noticed they were out of stock.  I was wondering if they are coming back and if so if there was an ETA ??

I never get tired of building Rat clones and the Slow Loris is one of the best sounding yet.  I tried both an LM308N and a OP07.  The OP07 sounded better to me so I left it in, go figure