I started a Krunkee build about 2 years ago, and got done except for putting it in a box. It was never tested at that time, though. Life got in the way, is why I never finished it, or any other pedals for that matter.
Anyway, fast forward 2 years, and I finally decided to box it up. I reused a box that already had a switch, jacks, led, and power already in it, so all I had to do was spliced the ins and outs together.
Unfortunately, it doesn't work. I can get a little sound out of it with the volume and gain all the way up, but it's only a faint farty octave like sound. I can't see the clipping LEDs lighting up either.
I've gone over the pads and traces to make sure there were no solder bridges. Beyond that, I really don't know what to do. I know the IC works, because I tried it in another pedal.
Any ideas what could be causing this?
Anyway, fast forward 2 years, and I finally decided to box it up. I reused a box that already had a switch, jacks, led, and power already in it, so all I had to do was spliced the ins and outs together.
Unfortunately, it doesn't work. I can get a little sound out of it with the volume and gain all the way up, but it's only a faint farty octave like sound. I can't see the clipping LEDs lighting up either.
I've gone over the pads and traces to make sure there were no solder bridges. Beyond that, I really don't know what to do. I know the IC works, because I tried it in another pedal.
Any ideas what could be causing this?