Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Ricotjuh

Pages: [1]
1
General Questions / Voodoo Lab/DMC GCX audio switcher
« on: February 05, 2021, 03:52:26 AM »
Maybe silly question, but does anyone own a Voodoo Lab/DMC, GCX audio switcher?
I am working on a DIY Looper/switcher where I want to use the concept of the Looper/analog part from the original, and the digital control is DIY.
The only thing I am not clear yet, is the component data of the capacitor and resistor that is used as an RC network on the coil.
So if anyone has this switcher and has the ability to unscrew the cover, would you be so kind as to take a close-up picture of it? So that I can clearly read the resistor values and capacitor value. And if it is also possible, also photo of the transistor, then I get it right.

2
General Questions / Boss CE-2W schematic or gutshots someone?!
« on: November 02, 2020, 04:19:38 PM »
Anyone have more technical information about the Boss CE-2W? I am very curious about the mods on the standard CE-2.
So does anyone have a schematic or gutshots of this pedal?
Or maybe someone has this pedal and can take gutshots of the PCB? I am very curious about this.

3
Build Reports / Small Clone and Small Stone builds
« on: October 28, 2020, 01:54:16 PM »
This project has been at a standstill for a long time, but this week I have just finished.
These are the Small Clone and the Small Stone. Built in the past with Tonepad PCBs. Now redrawn with all components on the PCB. This means no more loose wires are soldered. With the exception of the 9V power supply. This comes through a connector on the PCB.
Both PCBs fit exactly in a type B housing. Without a 9V battery, but I don't use it anyway.
The Small Clone works properly.
The Small Stone has a few issues. However, at a high Rate I hear an LFO tap. I was able to reduce this by placing a 1uf capacitor over input 2 and 3 of ic5.
In addition, there is an audible volume difference when I switch the color switch.
Which is strange when you consider that this should only affect the feedback loop. This changes the phaser operation, you should get a more extreme phasing sound.
This also happens, but with some sort of volume drop.
Do more people have problems / experience with this?


4
General Questions / MIDI question
« on: December 13, 2019, 03:43:20 PM »
I am completely new to the MIDI protocol, but I want to use it to switch my amplifiers and pedals. My pedals are then placed in a 19" rack and I only have my MIDI controller on the floor.
Now I have a Kitty Hawk foot controller, a Nobels ms-8 MIDI replay switcher and a DIY midi switcher from JimKim. But what strikes me now is that the program numbers do not match the number on my foot controller. For example, if I press switch 5, it will neatly read "05" on my foot controller. But on my receiver it indicates program "06". I have the idea that my foot controller counts from 0-127 (actually only from 0-99 since I only have 2 digits), because I can also set program "00". But my receivers count from 1-128. Can this just be true? And can this be changed?? My autistic brain would like to see 2 identical numbers: :)



Pages: [1]