Hey guys,
It's my first timing posting on this forum so if i'm in the the wrong place to seek aid, feel free redirect me.
I've build the florist chorus/vibrato but i have no (modulated) audio when the effect is activated.When the blend pot is at zero, the audio comes trough so i assume my off board wiring is correct( triple-checked everything). My pin voltages are all fine, the speed led works fine and follows the speed knob. During the troubleshooting i noticed there was no voltage on any of the bloom pots pins. C15 and c17 ( caps right in front of the pot) both have one leg with zero voltage on. I tried replacing the caps but the problem persists on the new caps.
Could this be a faulty pot?
I did use the 2n5458 instead of the 2N5457 because it wasn't directly available to order in Europe so maybe this could also cause some troubles?.
Would love to hear some feedback from you guys.
Thanks in advance!
Sam
It's my first timing posting on this forum so if i'm in the the wrong place to seek aid, feel free redirect me.
I've build the florist chorus/vibrato but i have no (modulated) audio when the effect is activated.When the blend pot is at zero, the audio comes trough so i assume my off board wiring is correct( triple-checked everything). My pin voltages are all fine, the speed led works fine and follows the speed knob. During the troubleshooting i noticed there was no voltage on any of the bloom pots pins. C15 and c17 ( caps right in front of the pot) both have one leg with zero voltage on. I tried replacing the caps but the problem persists on the new caps.
Could this be a faulty pot?
I did use the 2n5458 instead of the 2N5457 because it wasn't directly available to order in Europe so maybe this could also cause some troubles?.
Would love to hear some feedback from you guys.
Thanks in advance!
Sam