The BOM shows three 1/8w 100 ohm and one 1/4w 100 ohm resistor. However, there is no documentation on which resistor is the 1/4w. Does it matter as long as there is a 1/4w resistor in the circuit?
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Questions / Source for low profile electrolytic caps?
January 14, 2022, 06:13:36 PM
Seeing as Small Bear isn't restocking, I've tried Google to find another source, but can only find stuff like SMD caps. Neither Tayda nor Mouser seem to have them.
#3
General Questions / 1/4w VS 1/8w resistors
May 01, 2021, 08:05:04 AM
If I've rwad and understood it correctly,1/4w resistors can be used in place of 1/8w resistors with little issue, but not vice versa, correct?
#4
General Questions / Question about film caps
January 11, 2021, 10:18:39 PM
I'm looking for nanofarad film caps for my Donut, but all I find are micro and pico caps. I know 47nF is .047uF. Are these values interchangeable in capacitors?
Pages1