I have finally got round to boxing up a very old krankosaurus board. This is my first build, please excuse the mess. I decided to use these breakout boards and I don't think I understood enough to do so and they have given me grief.
The effect works both distortion and boost, but only the boost LED comes on when engaged. I have attached photos of the build below.
I feel like it has something to do with the fact that there is no 9v connected to the second breakout boards 9v(board) or DC in. I don't really know what I'm doing though. There is only one 9v wire off the effect PCB which goes to the breakout board on the left. The holes aren't big enough to put a second wire in the breakout board or the effect PCB. Should I be running a second wire from the DC jack 9v+ to the second breakout board. If so does it go to the DC in or the 9v in? Or am I on the wrong track completely?
The effect works both distortion and boost, but only the boost LED comes on when engaged. I have attached photos of the build below.
I feel like it has something to do with the fact that there is no 9v connected to the second breakout boards 9v(board) or DC in. I don't really know what I'm doing though. There is only one 9v wire off the effect PCB which goes to the breakout board on the left. The holes aren't big enough to put a second wire in the breakout board or the effect PCB. Should I be running a second wire from the DC jack 9v+ to the second breakout board. If so does it go to the DC in or the 9v in? Or am I on the wrong track completely?