Topics

Hi, I have a 2010 mudbunny that I would like to build. The oldest document I could find is the 2012 version on yumpu. The Archive version only goes back to 2014. I've been trying google over the last 2 days and I can't find anything. Can someone post the 2010 schematic (so I can match part numbers) or build document if there are any errors on the pcb? (I know some boards of that era had errors here or there)

Thanks.

Hi, I'm trying to wrap my head around putting 2 different fuzz faces (mangler and violenzz) in the same enclosure. I would really like to have dual pots so I can control the volume and fuzz of each with only 2 knobs while having a switch to change between the Ge and Si circuits. I have an old version of the mangler (2011) so I plan to use a road rage for the -9v. 

Basically my question is, how can I run both circuits in the same enclosure? I've built a lot of pedals, but never a PNP, and for some reason how to run both of these from the same power supply is confusing the crap out of me.
Since I will be switching between circuits anyway (only one will be active at a time), if I just use a 4PDT toggle or something, can I switch the voltage that way?

As far as hooking it up, would I basically wire the power jack as normal, and then use the regular ground as the ground for the PNP circuit and the -9v from the road rage to power it? So basically, the ground would be the same on both circuits, but one would be +9v from the power supply and the other would be -9v from the inverter?

Could I use a sag control with this configuration? Where the ground didn't change, only the voltage polarity?


I've looked around the internet, and haven't found a satisfactory answer to this question which is why I'm asking here.

Thanks in advance

Alex