Topics

Hey guys,

Has anyone successfully used a Morley inductor (specifically a Bad Horsie) in a Weener build? Just wondering if there's anything special that needs to be done - like the recommended small resistor in series with the standard Dunlop black inductors.

I seem to remember seeing a very cool YouTube video of one of Mr. Gagan's modded CryBaby builds with a Morley inductor but I can't remember if he went into any details.

Hi all,

Just wondering if any has run across this. I just finished a Kingslayer build (buffered). It works fine in bypass mode (which tells me the buffer is probably okay). When engaged, it works fine for about 10 seconds, although none of the clipping modes seem to make a difference in sound. After 10 seconds or so it goes into a weird power cycling death loop where the power cuts in and out (LED flashes on and off as well). It gets faster if I let it go on. I checked for solder bridges, etc. and all is well. I've built literally 20 or more Klons with other PCB's and have never run into this. I'm using a TC1044SCPA for regulator.

Any ideas?

So, I managed to avoid the hype as long as I could. I bought a Sunking board from Gaetano a couple weeks ago, and I'm pleasantly impressed with the sound of this thing.

Not the most impressive enclosure but I was proud that it worked the first time I plugged it in.

Hi all,

Has anyone built the new FatPants that could maybe share their voltages on Q1 & Q2. Mine works, but all of the gain is bunched up in the last 10 degrees of the "fat" pot rotation (4:00-5:00). Cranked full out with the volume and fat maxed and the body switch on, I get just above unity gain. Is this normal?

Thanks,
Mike

Does anyone happen to have the old PDF instructions for the EgoDriver (pre Sept '11) - or is there a section of the forums for retired build docs? I'm catching up on some builds and just noticed that this one is different from the board that I have.

Thanks!